Schlage FE469NX LAT 619 CEN Manual de Instruções descarregar pdf (Página 8)

English

6e Test bolt alignment.

1. Close the door.

2. Insert a athead screwdriver into the slot in the bolt, as shown.

3. Rotate the screwdriver toward the door edge to extend the bolt into the hole in the frame.

This operation should be smooth. You should be able to rotate the screwdriver 90˚, fully

extending the bolt.

4. If the operation was not smooth, or if the bolt did not fully extend, adjust your frame and/or

door preparation. Go to  and watch the video 

 for further instructions.

5. Retract (unlock) the bolt before continuing to step 7.

L If the deadbolt continues to rub against the strike, contact Customer Support for an

alternate strike with an additional .060” (2 mm) clearance.

Retract the bolt

before continuing

to step 6.

CAUTION

Test from the inside to

avoid being locked out!

If you can rotate the

screwdriver a full

90˚, then the bolt is

fully extended.

7 Install the Touchscreen Assembly.

7a Install the Touchscreen on the outside of the door.

L The clips snap into the to assist in holding the

keypad on the door.

L The Touchscreen Assembly should install smoothly. If it does not, check that the bolt is set

to the correct  .

Clips snap into

the .

Align the tab

with the notch.

Route the cable

under the bolt.

L NOTE: If you have a  that is slightly less than 2Z\,”

(54 mm), the lock may not install smoothly. You can remove the spacer. Always remove

the spacer for a 1Z\x” (38 mm) crossbore. See  before

continuing.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 48 49

Sem comentários

Schlage FE469NX LAT 619 CEN Manual de Instruções Página 8